Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Boulder?
Spring replacement in Boulder typically costs $180 – $340 for a single torsion spring, including the spring, labor, and a balance check. Most Boulder homes run a matched pair, so a two-spring replacement usually lands around twice that range. The written estimate you get on site sets the final price, and estimates are free.
If your door is stuck open, hanging crooked, or making a sharp bang from the torsion bar, call (855) 694-6347. We treat a broken spring as an emergency, not a scheduled inconvenience, and we send the same experienced technicians for urgent calls as for booked appointments.
Key Takeaways
- One torsion spring in Boulder: typically $180 – $340. A matched pair: about double.
- Extension springs, high-lift doors, and older hardware push the price higher.
- Our technicians have up to 11 years of experience, and spring work is a named specialty for us, not a side job.
- Estimates are free, pricing is upfront, and we stand behind the work with a satisfaction guarantee.
- Never wind or unwind a torsion spring yourself. More on that below.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers typically shake out for Boulder homeowners. These are estimated ranges for the Boulder market, and the written estimate you receive is what you actually pay.
| Line item | Typical estimated range |
|---|---|
| Single torsion spring replacement (spring + labor + balance) | $180 – $340 |
| Matched pair of torsion springs | About twice the single-spring range |
| Extension spring replacement (per spring) | Comparable to torsion, quoted per door |
| Cable repair, when a snapped cable comes with the spring | $130 – $250 |
| Roller replacement alongside the spring job | $110 – $220 |
| Track realignment if the door jumped the track | $120 – $240 |
| Panel replacement if the door came down hard | $250 – $500 |
| General garage door repair call (broader diagnosis) | $150 – $600 |
| Opener repair or opener installation, if the opener was stressed | $120 – $320 / $250 – $550 |
| New door installation, if the existing door is past saving | $700 – $2200 |
Springs are the most common failure on any garage door, and they tend to fail together. When one spring on a matched pair breaks, the other has lived the same number of cycles, so most technicians recommend replacing both at once. That’s why a pair costs about twice a single spring: it’s two springs, not a markup. Skipping the second spring usually means paying for a second service call a few months later.
What drives the price up or down is mostly the hardware on your door. A standard 7-foot torsion setup on a single-car door sits at the low end. A high-lift door for a lifted truck, a double door with heavy insulated panels, or an older door with rusty drums and worn cables all add labor and parts. If the door came down hard when the spring let go, the technician will check the panels and tracks too, and that’s where a spring job can turn into a broader repair.
If what you’re facing is a snapped cable rather than a spring, that’s a different job and a different price. Our Boulder Garage Door Repair Pros page covers the full range of what we handle, and our spring replacement page walks through the process in detail.
What Affects Spring Replacement Pricing in Boulder
- Spring type and door weight. Torsion springs on a standard single door are the most common job in Boulder and sit at the low end of the range. Heavy double doors, insulated panels, and carriage-style doors need heavier springs and more labor.
- High-lift and low-headroom setups. A door that lifts higher than standard, common in Boulder homes with tall garages or storage above, needs longer cables and different drums, which adds to the job.
- Age of the surrounding hardware. On an older door, the drums, cables, and bearing plates are often as worn as the spring. Replacing the spring alone on tired hardware tends to fail again quickly, so the technician will quote what actually needs to change.
- Whether one or both springs are replaced. This is the single biggest swing on the bill. One spring is the base range; a matched pair is about double.
- Frozen or seized components. Boulder’s dry air and hard freeze-thaw swings in winter can leave torsion hardware stiff and corroded. A spring job on a door that hasn’t been serviced in years takes longer to free up and rebalance.
- Emergency timing. A door stuck open to the street gets priority, and we handle these as a standard part of our service, not a premium add-on. Call and we’ll get a technician out as fast as we can.
How to Save on Spring Replacement
The honest answer is that spring replacement isn’t a job to shop purely on price. A cheap spring with the wrong wind count or a lower cycle rating will fail early, and you’ll pay twice. That said, there are real ways to keep the bill reasonable.
- Get the pair quoted together. Replacing both springs in one visit is almost always cheaper than two separate calls, even though the parts cost more up front.
- Ask what else is worn. If the cables and rollers are near the end of their life, bundling the work into one visit saves you a second service call later.
- Book before the door fails. A spring that’s visibly stretched, gapped, or making noise is a warning. A scheduled replacement is cheaper than an emergency repair on a door that came down hard.
- Get a free written estimate. We quote the job in writing before any work starts, so you know the price before the technician picks up a winding bar. Call (855) 694-6347 to set one up.
- Don’t DIY it. We’ll say it plainly: a torsion spring under tension can cause serious injury in a fraction of a second, and the tools to wind one safely aren’t in a typical homeowner’s garage. This is the one garage door repair we tell people never to attempt themselves.
Why Spring Work Is a Specialty, Not a Side Job
Springs are the part of a garage door that carries the full weight of the door. Getting the wind count, the cycle rating, and the balance right takes experience and the right tools. It’s also the repair most often botched by general handymen who treat a garage door like any other household fix. Our technicians have up to 11 years of experience, and spring repair is a named service for us because it’s the one that demands the most care.
We work on every major brand you’re likely to have on your door, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That matters for springs because brand-specific hardware and opener tension settings vary. A technician who knows your door and your opener diagnoses the actual problem rather than guessing at a generic fix.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Boulder?
Spring replacement in Boulder typically costs $180 – $340 for a single torsion spring, and a matched pair runs about twice that. The written estimate sets the final price. Call (855) 694-6347 for a free quote.
Do I need to replace both springs or just one?
Most of the time, both. A matched pair has lived the same number of cycles, so when one breaks the other is usually close behind. Replacing both in one visit costs about twice a single spring but saves you a second service call. Your technician will tell you honestly whether one will do.
Can you fix a broken spring today?
In most cases, yes. Emergency garage door service is a core part of what we do, and we send the same experienced technicians for urgent calls as for scheduled ones. Call (855) 694-6347 and we’ll get you on the schedule as quickly as we can.
Is it cheaper to repair the spring or replace the door?
Repair, almost always. A spring replacement at $180 – $340 is far less than a new door at $700 – $2200, and a sound door with a fresh spring will run for years. A new door only makes sense if the panels are rusted through, the door is badly bent, or you’re upgrading for other reasons. We’ll give you a straight answer either way.
Why does a matched pair cost about twice a single spring?
Because it’s two springs. The single-spring range of $180 – $340 covers one spring, labor, and balancing. A pair doubles the parts and adds a bit of labor, which is why the pair lands around twice the single. There’s no hidden upcharge in that number.
Can I replace a garage door spring myself?
No. A torsion spring is under extreme tension, and releasing or winding one without the right tools and training can cause severe injury. This is the one repair we always recommend leaving to a trained technician. It’s also why spring repair is a dedicated service for us rather than something we fold into general handyman work.
What brand of door or opener do you work on?
We handle the major brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Whether your door is a newer Clopay or Amarr or an older Wayne Dalton, and whether your opener is a legacy Craftsman or a current LiftMaster or Chamberlain, we’re familiar with the hardware and how it interacts with your springs.
When to Call for Spring Replacement in Boulder
Some signs are obvious and some aren’t. A loud bang from the garage followed by a door that won’t lift is the classic broken spring. But a door that feels unusually heavy, lifts a few inches and stops, or sits crooked is often a spring that’s stretched or weakened but hasn’t snapped yet. A visible gap in the coil is another warning. If you see any of these, don’t keep running the opener. The motor will strain against a door it can’t lift and can burn itself out, turning a spring job into a spring-and-opener job.
If your door is stuck open, exposed to the street, or too heavy to lift by hand, call (855) 694-6347. We treat that as an emergency and respond with the same expertise we bring to a scheduled appointment.
From a broken spring to a full new door, we cover the whole lifecycle, so you never have to find a second contractor as your needs change. Your opener, your door, our specialty. Whether you’re in North Boulder, Table Mesa, Gunbarrel, or anywhere else around town, we’ll get a technician out with a free estimate and upfront pricing, and we stand behind the work with a satisfaction guarantee.
Call (855) 694-6347 today for a free estimate on your spring replacement. Estimates are free, pricing is upfront, and our technicians have up to 11 years of experience getting doors right the first time.
Pricing reflects the Boulder market as of 2026. Boulder Garage Door Repair Pros offers free estimates – call (855) 694-6347.
Written by the team at Boulder Garage Door Repair Pros.
What Our Customers Say
"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Matt Fletcher"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Allen Yang"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Tara Gallagher