Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Spring Repair Across Boulder
A broken garage door spring in Boulder usually means a door you can’t lift, a car you can’t get out, and a house left open to the street. Call (855) 694-6347 and we’ll get a local technician out to assess it, quote the work in writing before anything starts, and replace the spring with one matched to your door’s actual weight and geometry.
We know Boulder doors. Between the narrow mid-century openings around Table Mesa and the heavier, oversized doors on acreage properties out toward the foothills, this is a city where off-the-shelf springs rarely fit and a proper match matters. Free estimates, upfront pricing, and a job finished in one visit wherever the parts allow.
Why Boulder Homeowners Call Boulder Garage Door Repair Pros for Garage Door Spring Repair
We work strictly on garage doors and openers, which means when a spring is the problem, you’re talking to a technician who does this daily rather than a generalist adding it to a list. That focus shows up in the diagnosis: correct wire gauge, correct inside diameter, correct wind count, verified against the door’s measured weight instead of guessed by eye.
Our technicians have up to 11 years of experience, and spring work is one of our named specialties rather than a sideline. When we connect you with a local professional, that pro is licensed and insured as their state requires, and arrives with the tools and winding bars a torsion job actually demands.
Response across Boulder is fast because this is our primary service area. A spring that fails leaves the door unsafe to use, so we treat it as urgent and offer same-day service where scheduling allows. From a broken spring to a full new door, you won’t need to line up a second contractor as your needs change.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Spring Repair Services in Boulder
Spring repair covers more than swapping a coil. Different doors carry different spring systems, and the right fix depends on what’s actually on your door header. Here’s what we handle across Boulder.
Torsion Spring Replacement
Torsion springs sit on a shaft above the door and do the heavy lifting for most modern and mid-century sectional doors. In Table Mesa and Martin Acres, the low-headroom setup means a standard off-the-shelf spring often won’t fit, so we match wire gauge, inside diameter, and length to your door’s weight and drum size. Many homeowners ask for high-cycle springs rated well beyond the usual count to avoid a repeat visit, and we’ll walk you through that option.

Extension Spring Replacement
Older Boulder homes and many single-car doors run on extension springs along the horizontal tracks, usually paired with safety cables. We replace them in matched pairs and install or replace safety cables at the same time, since a stretched or corroded cable is the reason a failed extension spring can become a hazard. If your door has this setup, we’ll confirm the hardware is rated for the door’s weight before we swap anything.

Broken Spring Repair
A snapped spring announces itself with a loud bang and a door that suddenly feels far too heavy. We diagnose whether the break is a simple spring failure or a symptom of imbalance, worn drums, or a cable about to go. On heavier custom or insulated doors, a standard-cycle spring is often what gave out, and we’ll recommend the cycle rating that fits how often your door actually runs.

Spring Adjustment
Not every problem is a break. A door that slams down, drifts back open, or strains the opener usually needs balanced spring tension rather than replacement. We adjust tension, check the door’s balance through its travel, and inspect the drums and end bearing plates for wear. That last check is what stops a tension fix from becoming a bigger repair two months later.
Trusted Brands We Service in Boulder
We’re factory-familiar with Raynor, LiftMaster, Chamberlain, and Genie systems, along with the other major door and opener brands, which means we diagnose brand-specific quirks instead of treating every symptom the same. If your door is a Raynor sectional or your opener is a LiftMaster or Chamberlain unit, we know how that hardware behaves under load. We don’t claim to stock parts locally; we source the correct spring for your door’s measurements and get it installed without guesswork. That approach gets most spring jobs done in a single visit.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Spring Repair Problems We See in Boulder Homes
- Spring failure on narrow mid-century doors. Boulder’s ranch and split-level homes often have an 8-9 ft single-car opening with low-headroom torsion springs, and a standard replacement won’t fit. Getting the wire gauge, inside diameter, and length right is the difference between a spring that lasts and one that fails early.
- UV degradation on south-facing doors. With roughly 300 days of sunshine a year and intense high-altitude UV, spring coatings and lubricants break down faster here than in lower, cloudier cities. That corrosion shortens spring life and is a common cause of premature breakage.
- Heavy or oversized doors on acreage properties. Detached workshops and larger doors out on Boulder’s edge push standard-cycle springs past their limit, leading to frequent breakage and extra strain on the opener. High-cycle springs and heavier-duty hardware are the usual answer.
- Freeze-thaw wear on older hardware. Boulder’s freeze-thaw cycles work on cables, drums, and end bearing plates as much as the spring itself. A technician who only replaces the spring and skips those checks leaves the next failure in place.
Pricing for Garage Door Spring Repair in Boulder, CO
Spring repair in Boulder typically runs $180-$340 for one spring, and that range covers the common torsion and extension replacements on standard residential doors. A matched pair is usually replaced together, so expect a pair to run about twice that range. Cable repair, when a cable went with the spring, is typically $130-$250. Heavier custom doors, high-cycle spring upgrades, and unusually tight low-headroom setups can sit at the upper end.
| Service | Typical Estimated Range in Boulder |
|---|---|
| Spring Repair (one spring) | $180-$340 |
| Cable Repair | $130-$250 |
Every price is quoted and agreed before any work starts, so the written estimate is what you pay. Estimates are free. A torsion spring holds the door’s full weight under tension and can cause serious injury if it’s handled without the right tools and training, so this is one job to leave to a trained professional rather than attempt yourself.
We Also Serve Cities Near Boulder
We also work in Louisville, Superior, Lafayette, and Erie, so if you’re just outside Boulder you’re still covered. Spring work on those doors follows the same rules. If you want the full picture of what our garage door spring repair service includes, that page covers the process in detail.
Serving Boulder, CO – Our Local Coverage Area
We serve Boulder and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Spring Repair in Boulder
Look above the door: a torsion spring is a horizontal coil on a metal shaft running the width of the opening, while extension springs run along the horizontal tracks on either side. Mid-century ranch homes in Boulder often have low-headroom torsion setups, and many older single-car doors use extension springs. If you’re not sure, we can confirm it during a free estimate.
Boulder’s intense high-altitude UV and freeze-thaw cycles wear spring coatings, lubricants, and surrounding hardware faster than in cloudier, lower climates, and the city’s many narrow mid-century doors compound it because a wrong-fit spring fails early. Heavy acreage doors also overstress standard-cycle springs. Call (855) 694-6347 for an exact quote on your door.
We usually recommend replacing both torsion springs together. Matched springs wear at the same rate, so if one failed, the other is close behind and you’ll pay for a second visit soon after. A pair costs about twice the one-spring range. Call (855) 694-6347 and we’ll give you a written price for either option.
Spring repair in Boulder typically runs $180-$340 for one spring, and a matched pair runs about twice that range. Cable repair adds roughly $130-$250 when a cable went with the spring. The written estimate sets the final price and is quoted before any work begins. Call (855) 694-6347 for a free estimate.
Yes. Extension springs should always run with safety cables threaded through them, because the cable contains the spring if it breaks. It’s a low-cost addition and we install or replace them as part of extension spring work. Call (855) 694-6347 to have yours checked.
If your door won’t lift or you heard that bang, don’t force it. Call Boulder Garage Door Repair Pros at (855) 694-6347 for a free estimate on garage door spring repair in Boulder, with the price agreed before any work starts.
Written by the team at Boulder Garage Door Repair Pros.